downloaded from a server to the switch to restore the switch to the. I am attaching a corrected file version below. About Dell EMC OpenManage Switch Administrator. Modify this xml file: c:\Program Files\Dell\SysMgt\apache-tomcat\conf\server.xmlĬonnector SSLEnabled="true" ciphers="SSL_RSA_WITH_RC4_128_SHA, SSL_RSA_WITH_RC4_128_MD5, SSL_DHE_RSA_WITH_3DES_EDE_CBC_SHA,TLS_DHE_RSA_WITH_AES_128_CBC_SHA, SSL_RSA_WITH_3DES_EDE_CBC_SHA, TLS_RSA_WITH_AES_128_CBC_SHA,TLS_DHE_DSS_WITH_AES_128_CBC_SHA, SSL_DHE_DSS_WITH_3DES_EDE_CBC_SHA"Ĭonnector SSLEnabled="true" ciphers="TLS_RSA_WITH_AES_128_CBC_SHA, TLS_DHE_RSA_WITH_AES_128_CBC_SHA, TLS_DHE_DSS_WITH_AES_128_CBC_SHA, TLS_RSA_WITH_AES_256_CBC_SHA, TLS_DHE_RSA_WITH_AES_256_CBC_SHA, TLS_DHE_DSS_WITH_AES_256_CBC_SHA, TLS_ECDH_ECDSA_WITH_3DES_EDE_CBC_SHA, TLS_ECDH_RSA_WITH_3DES_EDE_CBC_SHA, TLS_ECDHE_ECDSA_WITH_3DES_EDE_CBC_SHA, TLS_ECDHE_RSA_WITH_3DES_EDE_CBC_SHA, TLS_ECDH_ECDSA_WITH_AES_128_CBC_SHA, TLS_ECDH_RSA_WITH_AES_128_CBC_SHA, TLS_ECDHE_ECDSA_WITH_AES_128_CBC_SHA, TLS_ECDHE_RSA_WITH_AES_128_CBC_SHA, TLS_ECDH_ECDSA_WITH_AES_256_CBC_SHA, TLS_ECDH_RSA_WITH_AES_256_CBC_SHA, TLS_ECDHE_ECDSA_WITH_AES_256_CBC_SHA, TLS_ECDHE_RSA_WITH_AES_256_CBC_SHA, TLS_RSA_WITH_3DES_EDE_CBC_SHA, TLS_DHE_DSS_WITH_3DES_EDE_CBC_SHA, TLS_DHE_RSA_WITH_3DES_EDE_CBC_SHA, SSL_DHE_DSS_WITH_3DES_EDE_CBC_SHA, SSL_DHE_RSA_WITH_3DES_EDE_CBC_SHA, SSL_RSA_WITH_3DES_EDE_CBC_SHA, SSL_RSA_WITH_RC4_128_SHA, SSL_RSA_WITH_RC4_128_MD5, SSL_DHE_DSS_WITH_DES_CBC_SHA, SSL_DHE_RSA_WITH_DES_CBC_SHA, SSL_RSA_WITH_DES_CBC_SHA"Įverything before and after that should be left the same. If the above lines are not present add them in the /etc/snmp/nf and restart the Dell OMSA services and the SNMP daemon.
To update the boot code, follow the directions found within the PDF file supplied within the firmware zip.
Updating the boot code will require a command line interface set of instructions.
This process is not capable of updating the boot code. If the current address is not known or has not been set, an IP address will have to be set through console access before continuing. Note: The PowerConnect 6200 series switches do not have a default IP address.